Changed Windows RAID LD to IDE, FC10 can't mount
I used to have Windows XP installed on a RAID 0 volume, and a separate hard drive to store FC10 in its native partition layout (/boot and LVM). The RAID logical drive was detected by FC10 during installation, and I could mount it using ntfs-3g.
Later, I destroyed the Windows RAID 0 volume, set the controller to native IDE mode, and used the two member disks as individual NTFS volumes. The problem now is that I can't mount them in FC10. Physically, the NTFS volumes are /dev/sda1 and /dev/sdb1. Here's what fdisk -l lists:
Quote:
Disk /dev/sda: 160.0 GB, 160040803840 bytes
255 heads, 63 sectors/track, 19457 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x23de0de1
Device Boot Start End Blocks Id System
/dev/sda1 * 1 16708 134206978+ 7 HPFS/NTFS
/dev/sda2 16709 19457 22081342+ f W95 Ext'd (LBA)
/dev/sda5 16709 19457 22081311 b W95 FAT32
Disk /dev/sdb: 160.0 GB, 160040803840 bytes
255 heads, 63 sectors/track, 19457 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0xb75f8dbe
Device Boot Start End Blocks Id System
/dev/sdb1 1 19457 156288321 7 HPFS/NTFS
Disk /dev/sdc: 40.0 GB, 40019582464 bytes
255 heads, 63 sectors/track, 4865 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x00030ec5
Device Boot Start End Blocks Id System
/dev/sdc1 * 1 25 200781 83 Linux
/dev/sdc2 26 4865 38877300 8e Linux LVM
...where sdc1 and 2 are where FC10 resides.
When try to mount /dev/sdb1 using ntfs-3g, here's what I get:
Quote:
ntfs-3g /dev/sdb1 /mnt/windows
Error opening '/dev/sdb1': No such device or address
Failed to mount '/dev/sdb1': No such device or address
Either the device is missing or it's powered down, or you have
SoftRAID hardware and must use an activated, different device under
/dev/mapper/, (e.g. /dev/mapper/nvidia_eahaabcc1) to mount NTFS.
Please see the 'dmraid' documentation for help.
What do I do now? Please go light on the jargon, I'm very new to Linux.
